YOU ARE HERE:  > Products > Tractors > T6000 Elite > PTO and Hydraulics

PTO and Hydraulics

HYDRAULIC PERFORMANCE TO MEET YOUR DEMANDS


HYDRAULIC POWER AND PTO FLEXIBILITY

On Elite models, New Holland’s CCLS system provides up to 113Lpm of hydraulic performance to power even the most demanding implements. Regardless of how hard the tractor is working, the steering will always remain light and easy to use, as it is powered by a separate 40Lpm pump. If that wasn’t enough, New Holland has engineered the CCLS system to always operate at peak efficiency. The benefit? Full hydraulic power is always available at the remote valves and lift linkage, but only as much as is needed. The result? Reduced fuel consumption.

MECHANICAL REMOTE VALVES

The Elite models can be specified with up to four remotes, and feature flow control so you can fine tune the hydraulic performance to suit the task in hand. Although mechanically controlled, the valves can be configured to suit different applications. You can remove the detent, have constant pump or a motor mode just by rotating a dial on the valve.

MID MOUNT REMOTE VALVES

The T6000 range can be specified with two mechanical mid-mount remote valves to operate the front linkage or a loader. They are controlled via an ergonomic, fully integrated joystick in the cab.

ELECTRONIC DRAFT CONTROL

A single raise/lower switch makes it simple to lift and return an implement to work during a headland turn. How? New Holland’s ergonomic mouse is positioned on your right hand side, just where you need it, giving you ultimate precision. To fine-tune the system you can use the intuitive controls that are found underneath the armrest, right where you expect them to be. Independent control of the draft and position control delivers precise depth control without compromising your draft sensing ability.

AUTOMATIC PTO OPERATION

PTO engagement comes courtesy of a single push/pull switch with automatic soft start engagement. This adjusts according to the load to ensure the smooth uptake of power preventing damage when using high inertia implements, including balers. For the ultimate ease of operation, the automatic PTO can be set to automatically engage and disengage PTO drive. No need to worry about getting your timing wrong and damaging your implement, as it uses the position of the rear linkage to manage the engagement of PTO drive. External PTO controls are also standard.

STRONG, EFFICIENT AND POWERFUL

Measured at the ball ends, the Cat. 3 rear linkage has a continuous lift capacity of up to 7864kg on Elite models.